The influence of the interfacial slippage on the whole moving surface on the carried load and friction coefficient of an inclined fixed pad thrust slider bearing is analytically investigated. The calculation results show that the carried load of this mode of bearing is normally much lower than that of the conventional inclined fixed pad thrust slider bearing, while the friction coefficient of this mode of bearing is significantly higher than that of the conventional bearing, when the operating condition is the same. With the reduction of the contact-fluid interfacial shear strength on the moving surface, the performance of this mode of bearing is worsened. These results suggest the necessity of preventing the interfacial slippage on the moving surface in an inclined fixed pad thrust slider bearing.
Tzeng ST, Saibel E. On the Effects of Surface Roughness in the Hydrodynamic Lubrication Theory of a Short Journal Bearing. Wear 1967; 10: 179-84. https://doi.org/10.1016/0043-1648(67)90002-6
Rozeanu L, Snarsky L. Effect of Solid Surface Lubricant Interaction on the Load Carrying Capacity of Sliding Bearings. ASME J Lubri Tech 1978; 100: 167-75. https://doi.org/10.1115/1.3453130
Rozeanu L, Tipei N. Slippage Phenomena at the Interface Between the Adsorbed Layer and the Bulk of the Lubricant: Theory and Experiment. Wear 1980; .64: 245-57. https://doi.org/10.1016/0043-1648(80)90131-3
Jacobson BO, Hamrock BJ. Non-Newtonian Fluid Model Incorporated into Elastohydrodynamic Lubrication of Rectangular Contacts. ASME J Trib 1984; 106: 275-84. https://doi.org/10.1115/1.3260901
Zhang YB et al. An Analysis of Elastohydrodynamic Lubrication with Limiting Shear Stress: Part I-Theory and Solutions. Trib Trans 2002; 45: 135-44. https://doi.org/10.1080/10402000208982532
Yan J, Jiang X, Zhu Y, Zhang YB. An Analysis for a Limiting Shear Stress Effect in a Hydrodynamic Step Bearing. Part I. First Mode of Boundary Slippage for Film Breakdown. J Balkan Trib Assoc 2014; 20: 259-70.
Fortier AE, Salant RF. Numerical Analysis of a Journal Bearing with a Heterogeneous Slip/No-Slip Surface. ASME J Trib 2005; 127: 820-25. https://doi.org/10.1115/1.2033897